M Tech | Power Electronics

Mtech project and thesis help in delhi

Power Electronics

SIMULATION Projects List
2019-2020

1.   A Novel Design of Hybrid Energy Storage System for Electric Vehicles
2.  Design and Performance Analysis of Three-Phase Solar PV Integrated UPQC
3.  Rectifier Load Analysis for Electric Vehicle Wireless Charging System
4.  Development of a Bidirectional DC/DC Converter with Dual-Battery Energy Storage for Hybrid Electric Vehicle System
5.  Design and Implementation of Active Power Control with Improved P&O Method for Wind PV-Battery based Standalone Generation System
6.   Irradiance-adaptive PV Module Integrated Converter for High Efficiency and Power Quality in Standalone and DC Microgrid Applications
7.   Single-phase hybrid cascaded H-bridge and diode-clamped multilevel inverter with capacitor voltage balancing
8.   A Buck & Boost based Grid Connected PV Inverter Maximizing Power Yield from Two PV Arrays in Mismatched Environmental Conditions
9.   Power management in PV-battery-hydro based standalone microgrid
10. Control of a Three-Phase Hybrid Converter for a PV Charging Station
11.  Reduced carrier PWM scheme with unified logical expressions for reduced switch count multilevel inverters
12.  A New-Coupled-Inductor Circuit Breaker for DC Applications
13.  A Highly Efficient and Reliable Inverter Configuration Based Cascaded Multilevel Inverter for PV Systems
14.  A New Single-Phase Switched-Coupled-Inductor DC–AC Inverter for Photovoltaic Systems
15.  A Novel Structure for Single-Switch Non-isolated Transformer less Buck–Boost DC–DC Converter
16.  A Performance Investigation of a Four-Switch Three-Phase Inverter-Fed IM Drives at Low Speeds Using Fuzzy Logic and PI Controllers
17.  An Induction Generator-Based AC/DC Hybrid Electric Power Generation System for More Electric Aircraft
18.  Electric Spring for Voltage and Power Stability and Power Factor Correction
19.  Design and implementation of a high-performance technique for tracking PV peak power
20. Global Maximum Power Point Tracking Method for Photovoltaic Arrays Under Partial Shading Conditions
21.  Modelling and simulation for smart grid integration of solar/wind energy
22.  Photovoltaic Module-Integrated Stand-alone Single-Stage Switched Capacitor Inverter with Maximum Power Point Tracking
23.  A Seven Level Inverter using a Solar Power Generation System
24.  Adaptive Neuro Fuzzy Inference System Least Mean Square Based Control Algorithm for DSTATCOM
25.  Partial Shading Detection and Smooth Maximum Power Point Tracking of PV Arrays under PSC
26.  Standalone Photovoltaic Water Pumping System Using Induction Motor Drive with Reduced Sensors
27.  Single Stage PV Array Fed Speed Sensor Less Vector Control of Induction Motor Drive for Water Pumping
28.  A New Design Method of an LCL Filter Applied in Active DC-Traction Substations
29.  A Very High-Resolution Stacked Multilevel Inverter Topology for Adjustable Speed Drives
30.  Implementation and Comparison of Symmetric and Asymmetric Multilevel Inverters for Dynamic Loads
31.  Reconfiguration of NPC Multilevel Inverters to Mitigate Short Circuit Faults Using Back-to-Back Switches
32.  Irradiance-adaptive PV Module Integrated Converter for High Efficiency and Power Quality in Standalone and DC Microgrid Applications
33.  Dual-function PV-ECS integrated to 3P4W distribution grid using 3M-PLL control for active power transfer and power quality improvement
34.  ZSI for PV systems with LVRT capability
35.  Crisscross switched multilevel inverter using cascaded semi-half-bridge cells
36.  Single-phase hybrid cascaded H-bridge and diode-clamped multilevel inverter with capacitor voltage balancing
37.  Control of Solar Photovoltaic Integrated Universal Active Filter Based on Discrete Adaptive Filter
38.  A Buck & Boost based Grid-Connected PV Inverter Maximizing Power Yield from Two PV Arrays in Mismatched Environmental Conditions
39.  A Grid Connected Single Phase Transformerless Inverter Controlling Two Solar PV Arrays Operating under Different Atmospheric Conditions
40.  Single-phase multilevel inverter topologies with self-voltage balancing capabilities
41.  A Three-Phase Symmetrical DC-Link Multilevel Inverter with Reduced Number of DC Sources
42.  A Bridge Modular Switched-Capacitor-Based Multilevel Inverter with Optimized SPWM Control Method and Enhanced Power-Decoupling Ability
43.  Single-Phase Modified Quasi-Z-Source Cascaded Hybrid Five-Level Inverter
44.  Improved control algorithm for grid-connected cascaded H-bridge photovoltaic inverters under asymmetric operating conditions
45.  Power-decoupling of a Multi-port Isolated Converter for an Electrolytic-capacitorless Multi-level Inverter
46.  Verification of a low Components Nine-Level Cascaded-Transformer Multilevel Inverter in Grid Tie Mode
47.  Power management in PV-battery-hydro based standalone microgrid
48.  Hybrid Cascaded Multilevel Inverter (HCMLI) with Improved Symmetrical 4-Level Submodule
49.  Single-Stage Switched-Capacitor Module (S3CM) Topology for Cascaded Multilevel Inverter
50.  Combination Analysis and Switching Method of a Cascaded H-Bridge Multilevel Inverter Based on Transformers with the Different Turns Ratio for Increasing the Voltage Level
51.  Research on the Unbalanced Compensation of Delta-connected Cascaded H-bridge Multilevel SVG
52.  Autonomous Power Management for Interlinked AC-DC Microgrids
53.  Multi-Input Switched-Capacitor Multilevel Inverter for High-Frequency AC Power Distribution
54.  Phase Shifted Carrier Based Synchronized Sinusoidal PWM Techniques for Cascaded H-Bridge Multi-Level Inverter
55.  Autonomous Power Control and Management Between Standalone DC Microgrids
56.  Soft Switched Interleaved DC/DC Converter as front-end of Multi Inverter Structure for Micro Grid Applications
57.  Dynamic Power Management and Control of PV PEM fuel Cell-based Standalone AC/DC Microgrid Using Hybrid Energy Storage
58.  Modeling, Design, Control, and Implementation of a Modified Z-source Integrated PV/Grid/EV DC Charger/Inverter
59.  ISOGI-Q Based Control Algorithm for Single Stage Grid Tied SPV System
60.  An f-P/Q Droop Control in Cascaded-Type Microgrid
61.  Three-Phase Transformer less Shunt Active Power Filter with Reduced Switch Count for Harmonic Compensation in Grid-Connected Applications
62.  Control of a Three-Phase Hybrid Converter for a PV Charging Station
63.  Reduced carrier PWM scheme with unified logical expressions for reduced switch count multilevel inverters
64.  A Novel Hybrid Modular Three-Level Shunt Active Power Filter
65.  An Improved Modulated Carrier Control with On-Time Doubler for Single-Phase Shunt Active Power Filter

Last Updated :-05th Nov 2019

Procedure at XiLiR Technologies

1. Selection of topic IEEE Based | Selecting the right Tool
We guide Students to select the latest innovative topic on trending technologies. Students can come up with their own topics. We recommend selection Standard thesis topics from international journals like IEEE based.
We make Proper Synopsis on the Selected Topic with new work and technique to be implemented.

2. Topic Approval From your College Mentor/Guide
Your college mentor /Guide is the person who accepts the topic then we proceed further.

3. Literature survey
The literature survey is done for the topic you have selected from previous years papers.

4. The conclusion of the literature survey
Conclusion after Studying previous work on the selected topic.

5. Base Paper implementation
We guide students on how to make a working model of project from selected base paper.
Selected Base Paper is Implemented so that we can improve the result and Apply new Techniques for enhanced work.

6. Proposed work Implementation | Research Work
New techniques are Designed and applied to the Working model or Simulation Circuit for Enhanced results.
Complete Training is Given to the student on how to make a working model for your project.

7. New results and analysis
The new results from a working model are taken out and compared with the previous working model.

8. Get result Verification from your mentor
Verifying your work from college mentor/guide.

9. Thesis and Research paper Writing without Plagiarism.
Complete thesis and Research paper for Final submission in college / University. Thesis/paper are made and edited and are completely plagiarism free and report on plagiarism is given to the students.
We check thesis on the latest online software like Turnitin, plagiarism x checker etc .

10. Get Your Work Published in Leading Journals like IEEE, Scopus, UGC approved or as Required.
We help students to published their research in Internal journals or as required by students.

How to contact us

Students looking for best help in Delhi India Delhi can contact XiLiR technologies.XiLiR technologies best place of thesis-related problem whether it is for MTech or for Ph.D.

Feel Free to Contact us for any inquiry like selecting projects | New ideas | Synopsis 2019

You can contact or WhatsApp us on this any time

HINDI SPEAKING +91-9810326343

ENGLISH SPEAKING +91-9911331389

Email id : xilirtech@gmail.com

Call Now Button